Investigation into the effect of drilling parameters on delamination in drilling GFRP

Basit Öğe Kaydı
dc.contributor.authorKilickap, Erol
dc.date.accessioned2024-04-24T17:14:35Z
dc.date.available2024-04-24T17:14:35Z
dc.date.issued2010
dc.departmentDicle Üniversitesien_US
dc.description.abstractThe purpose of this article is to investigate the influence of the cutting parameters, such as cutting speed and feed rate, and point angle on delamination and surface roughness produced when drilling a glass fiber-reinforced plastic composite. All tests were run without coolant at cutting speeds of 5, 10, 15, 20, and 25 m/min and feed rates of 0.1, 0.2, 0.3, and 0.4 mm/rev and point angle of 118 degrees and 135 degrees. The damage generated associated with drilling GFRP composites was observed, both at the entrance and the exit during the drilling process. It was observed that the delamination on drilled holes increased with increasing cutting speed and feed rate. The best results of the delamination are obtained at lower cutting speed and feed rates. For minimum damage on drilled holes, glass fiber-reinforced plastic composite must be drilled at a lower feed rate. It is shown that the point angle of drill is an important parameter on delamination and surface roughness.en_US
dc.identifier.doi10.1177/0731684410386271
dc.identifier.endpage3503en_US
dc.identifier.issn0731-6844
dc.identifier.issue23en_US
dc.identifier.scopus2-s2.0-78650271399
dc.identifier.scopusqualityQ1
dc.identifier.startpage3498en_US
dc.identifier.urihttps://doi.org/10.1177/0731684410386271
dc.identifier.urihttps://hdl.handle.net/11468/18074
dc.identifier.volume29en_US
dc.identifier.wosWOS:000285160600009
dc.identifier.wosqualityQ2
dc.indekslendigikaynakWeb of Science
dc.indekslendigikaynakScopus
dc.language.isoenen_US
dc.publisherSage Publications Ltden_US
dc.relation.ispartofJournal of Reinforced Plastics and Composites
dc.relation.publicationcategoryMakale - Uluslararası Hakemli Dergi - Kurum Öğretim Elemanıen_US
dc.rightsinfo:eu-repo/semantics/closedAccessen_US
dc.subjectPolymer Matrix Compositesen_US
dc.subjectDrillingen_US
dc.subjectDelaminationen_US
dc.titleInvestigation into the effect of drilling parameters on delamination in drilling GFRPen_US
dc.titleInvestigation into the effect of drilling parameters on delamination in drilling GFRP
dc.typeArticleen_US

Dosyalar

Koleksiyon

WoS İndeksli Yayınlar Koleksiyonu
Scopus İndeksli Yayınlar Koleksiyonu