Evaluation of Microleakage Caused by Different LED Light Sources in Composite Resins with AutoCAD Program
[ X ]
Tarih
2020
Dergi Başlığı
Dergi ISSN
Cilt Başlığı
Yayıncı
Sci Printers & Publ Inc
Erişim Hakkı
info:eu-repo/semantics/closedAccess
Özet
OBJECTIVE: To use AutoCAD software to examine the microleakage of bulk-fill composites occurring as a result of polymerization with different light sources. STUDY DESIGN: In a total of 40 extracted first molar teeth, class I cavities were opened. Then 4 groups were formed of 10 samples in each group. All the samples were restored with SDR bulk-fill composite. The samples were polymerized with an LED light source as follows: Group 1, Mikado; Group 2, Woodpecker; Group 3, Planmeca; and Group 4, CarboLED. Each tooth was divided into 2 sections. Each section was examined under stereomicroscope, and the dimensions of the leakage surface area were measured with AutoCAD software. In the statistical evaluations of the data, the Kruskal-Wallis and Tukey B tests were used. RESULTS: Significant differences were found between the groups in the statistical evaluations (p <0.05). The highest value was found in the CarboLED group and the lowest value was found in the group where Mikado light source was used. CONCLUSION: There are many factors affecting polymerization. Since there are insufficient studies on this subject, it should be supported with new research.
Açıklama
Anahtar Kelimeler
Autocad, Bulkfill Composite, Micro-Leakage, Stereomicroscope
Kaynak
Analytical and Quantitative Cytopathology and Histopathology
WoS Q Değeri
Q4
Scopus Q Değeri
Q4
Cilt
42
Sayı
4
