Optimisation of surface roughness with GA approach in turning 15% SiCp reinforced AlSi7Mg2 MMC material
[ X ]
Tarih
2006
Yazarlar
Dergi Başlığı
Dergi ISSN
Cilt Başlığı
Yayıncı
Erişim Hakkı
info:eu-repo/semantics/closedAccess
Özet
In this study, 15% SiCP reinforced Metal Matrix Composite (MMC) AlSi7Mg2 material was turned by an uncoated WC cutting tool (K10) at cutting speeds of 50, 100 and 150 m/min, feed rates of 0.1, 0.2 and 0.3 mm/rev and depths of cut of 0.5, 1 and 1.5 and surface roughness values have been examined after each workpiece machined. A mathematical expression was derived by means of regression analysis method using the results obtained from the experiments performed under these conditions. Then, with the help of this expression, optimum turning parameters for minimum surface roughness were found via Genetic Algorithm (GA).
Açıklama
Anahtar Kelimeler
Genetic Algorithm (Ga), Optimisation, Surface roughness, Turning parameters
Kaynak
International Journal of Machining and Machinability of Materials
WoS Q Değeri
Scopus Q Değeri
Q2
Cilt
1
Sayı
4
Künye
Özel, C. ve Kılıçkap, E. (2006). Optimisation of surface roughness with GA approach in turning 15% SiCp reinforced AlSi7Mg2 MMC material. International Journal of Machining and Machinability of Materials, 1(4), 476-487.
